GREAT PLANES L-39 Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES L-39. GREAT PLANES L-39 16 páginas. Electrifly series

❏

13. The vertical ﬁ n and horizontal stabilizer are keyed

to ﬁ t together and therefore must be glued in place at the

same time. Coat with epoxy the key on the bottom of the ﬁ n,

the slot in the horizontal stabilizer, and the stab saddle on

the fuselage. Do not put epoxy on the foam piece glued to

the front of the ﬁ n that ﬁ ts into the ducted fan access hatch.

Position the parts onto the fuselage, making sure that the

vertical ﬁ n is being glued square to the horizontal stabilizer.

The parts can be taped in place while the epoxy cures.

❏

14. Glue the elevator servo into the elevator servo bay inside

the radio compartment with the splines facing forward. There

is a slot at the bottom of the servo bay for the servo lead.

❏

15. Cut three arms from a four-armed servo arm. Enlarge

the outer hole of the servo arm with a 1/16" [1.6mm] drill

bit. Attach the screw-lock connector to the outer hole of the

servo arm and secure it with the plastic retainer.

❏

16. Make a small, upward bend in the elevator pushrod

as shown. Fit the pushrod through the screw-lock connector

and attach the servo arm to the servo using the servo arm

screw. Insert the 90° bend (at the aft end) into the outer hole

of the elevator control horn. Secure it using the 90° pushrod

connector. Use your radio system to center the elevator servo.

Position the elevators in the neutral position and tighten the

screw-lock connector against the pushrod.

❏

17. Connect your ESC to the motor lead extensions and

connect the servos and ESC to the receiver. This is a good

time to conﬁ rm the correct rotation of your ducted fan unit. If the

unit rotates the wrong direction when powered up, disconnect

two of the three motor leads and swap their positions.