GREAT PLANES Spectra Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES Spectra. GREAT PLANES Spectra 16 páginas.

Radio & Motor Installation

1. Find the two hardwood sticks. The longer one is 1/4" x

3/8" x 2-1/8" [6.3mm x 9.5mm x 54mm] and it should be

inserted at the front of the radio tray slot. Insert the shorter

stick (1/4" x 3/8" x 1-15/16" [ 6.3mm x 9.5mm x 49mm]) at the

back of the slot. Test fit the servos you are going to use between

the sticks and then glue the sticks in place with CA.

2. Install the servos using the hardware included with

your radio system. Note the location of the servo output

shafts in the photo.

3. Install the motor on the firewall using two supplied

3mm x 10 mm bolts and two 3mm washers.

4. Install the receiver, speed control and switch. Follow

your speed control manufacturer's instructions closely. Use

thin foam to cushion the receiver. A Great Planes C-30 speed

control (GPMM2030) was used on the instruction model.

5. Make a hole on the side of the fuselage and route the

receiver antenna through the hole to the rear end of the

fuselage. Use fuel tubing through the hole to work as strain

relieve system. Also, use a cut piece of servo arm and guide

the antenna through at least two holes to act as a retainer.

Tie the end of the antenna to a small rubber band and use

a pin to hold the antenna in place at the rear fuselage.

6. Install the motor battery. Make sure there is enough

room in the front compartment to allow the motor battery to

slide out. The space is tight, so an option to remove the

battery is to remove the wing.

7. Find the two 12" (305mm) threaded one end pushrod

wires and make a cut 5" [127 mm] away from the end on the

unthreaded part of the rod. You should end up with two 5"