GREAT PLANES synapse arf Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES synapse arf. GREAT PLANES synapse arf 12 páginas.

it out from the bottom. Because of this, we suggest marking

the location of the ducted fan unit on the underside of the

lower duct channel half. You can do this by pushing T-pins

through the inside of the duct channel half along the edges of

the mold lines. The holes left on the underside of the channel

half from the T-pins can be connected with a drawn line for

future reference. If at any time you need to remove the fan

unit, use a hobby knife to cut along the holes left by the T-pins

to extract the unit out of the bottom of the plane.

❏

10. Use thick CA glue or mix up approximately 3/8oz [5cc]

of epoxy to glue the lower duct channel half onto the fuselage.

Coat the area in duct channel half between the fan unit mold

lines with a thin coat of glue or epoxy. Coat the edges of the

duct channel half (being sure to use enough adhesive along

all contact surfaces) and press the piece into place aligning

the front air intake edges with the underside of the fuselage.

Wipe away any excess glue with a dry paper towel.

❏

11. Glue the aft duct channel ring into place with thick CA

glue or epoxy.

❏

12. Connect the servos and ESC to the receiver. Install

the receiver and ESC in the locations shown. They can be

secured using small pieces of the included hook and loop

material or double-sided foam servo tape (not included).

❏

13. The receiver antenna can be taped to the side of

the fuselage anywhere that it will not interfere with the duct

channel or canopy. For a clean look, we drilled a 3/32" [2.4mm]

diameter hole from the front of the lower duct channel where

it meets the fuselage up to the radio compartment. Be very

careful not to drill into the duct channel. Feed the receiver

antenna through the hole and out the bottom of the fuselage.

The antenna can then be tucked into the seam between the

lower duct channel and the fuselage. A few drops of thick CA

glue will prevent the antenna from falling out of the seam.