GREAT PLANES YAK 55 Manual de instrucciones - Página 11

Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES YAK 55. GREAT PLANES YAK 55 16 páginas. 3d ep with flightflex

servo. Slide a 3-1/8" X 1/32" [80mm x 1mm] carbon rod through

the clevises on the servo and the control horn. Adjust the linkage

by sliding the rod in the clevises until you have the elevator

straight when the servo is centered. Once you are satisfied with

the linkage, secure it with a small drop of thin CA between the

clevises and the rod. Be very careful not to get CA in the

pivoting joint between the horns and the clevises.

❏

16. Set up the rudder linkage using the same technique.

❏

17. Set up the aileron linkages using the same techniques. In

this case, both servo arms should be installed perpendicular to

the fuselage when the ailerons are in the neutral position. This

will create a small amount of aileron differential.

❏

18. Check that all of the servo arm screws are installed

in the servos.

Install the Propulsion System

❏

1. Pull the ESC output wires forward from the canopy and out

the hole in the firewall using the preinstalled string if necessary.

❏

2. Connect your ESC output wires to the motor. If using

a different ESC than the one recommended, soldering may

be necessary. If soldering, attach the wires to the same point

that the capacitors and brush wires are pre-soldered to. The

positive wire from the ESC connects to the identified red

post. Check for proper rotation before proceeding.

❏

3. Slide the gearbox assembly onto the motor stick. Align

the front of the gearbox 1-3/4" [44mm] from the firewall and

secure it with a 2 x 6mm [#2 x 1/4"] wood screw.