GREAT PLANES ZERO Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES ZERO. GREAT PLANES ZERO 16 páginas. Electrifly series

Install the Horizontal Stabilizer

❏

1. Roughen a 1/8" [3mm] strip down the center of the top

and bottom of the horizontal stabilizer. Use alcohol to dull

the paint at the area to be glued. Do the same to the area

around the horizontal stab slot in the fuse.

❏

2. Center the stab left and right in the fuse. Make sure the

stab is square to the fuse by measuring the distance

between the wing tips and stab tips and setting them equal

to each other as shown in the photo. Before gluing, stand

back several feet and view the model from behind. The stab

should be parallel to the wing. If not, you will need to hold the

stab in the correct position as you glue it to the fuse.

❏

3. When satisfied, run a bead of thick CA glue along the top

and bottom of the stab where it meets the fuse on both sides.

❏

4. Glue the two tail doublers to the aft end of the fuse

as shown.

Install the Tail Servos & Linkages

❏

1. Glue the rudder and elevator servos into the cutout in

the fuse with the output splines both facing the front of the

plane. The servo in the bottom of the slot is the rudder servo

and should be installed with the splines on the left side of

the fuse. The servo in the top of the slot is the elevator servo

and should be installed with the splines on the right side of

the fuse. Both servo leads should exit out of the right side.