Emergi-Lite HP Series Manual - Página 2

Navegue en línea o descargue pdf Manual para Mando a distancia Emergi-Lite HP Series. Emergi-Lite HP Series 2 páginas. Remote heads for hazardous locations

Imprimir página

6. Thread the wire conduit(s) tightly into the conduit fitting(s) ensuring a

water-tight seal. If necessary, seal with silicone or equivalent caulking

(not provided) to prevent water from leaking into the cabinet.

FAILURE TO ENSURE A WATER-TIGHT

INSTALLATION OF THE CONDUIT(S) AND

WARNING:

FITTING(S) WILL VOID THE MANUFACTURER

WARRANTY.

7. Take the unit cover with lamps and hang it temporarily from the hook

located inside the back box.

8. Attach one of the ground wires to each screw located on the nut of the

conduit fitting.

9. Connect the left over ground wire(s) to the incomming wire conduit

ground wire.

10. Respecting the proper polarity {red (+) and black (-)}, connect the lamp

wires to the emergency circuit (low-voltage 12-24Vdc) using wire nuts.

11. Verify that the gasket is installed and well aligned in the groove of the

cover.

12. Unhook and install the cover onto the back box with the lamp heads

pointing downwards. Tighten the four screws to prevent water

infiltration.

SCREWS MUST BE TORQUED TO AT LEAST

WARNING:

12INLB TO ENSURE A WATER-TIGHT SEAL

BETWEEN THE COVER AND HOUSING.

13. Adjust the lamp head assemblies:

- Rotation: hold the lamp assembly and turn it to either side.

- Tilting: hold the lamp assembly and tilt it up or down.

If the lamp heads become loose: tighten the screws located on each side

of the lamp heads and the nut located at the base of the bracket

(See figure 3).

Warranty: For the complete warranty information, please

refer to the landing page of our website (http://www.emergi-lite.com/usa/).

Emergi-Lite®

Tel: (888) 552-6467

Fax: (800) 316-4515

HP Series Remote Heads for Hazardous Locations

Figure 3

www.emergi-lite.com

Nut

Two screws

(located on both sides

of the lamp head)

11/17 750.0024 Rev. A

2/2