HiBoost F12G-3S-BTW Manual del usuario - Página 10
Navegue en línea o descargue pdf Manual del usuario para Extensor HiBoost F12G-3S-BTW. HiBoost F12G-3S-BTW 13 páginas.
Imprimir página2. Check cable for bends and or cuts.
3. All LED lights on the booster should be blue.
4. Outdoor antennaand the indoor antennas have adequate separation and are not
causing feedback.
6 FREQUENTLY ASKED QUESTIONS
WHY ARE THE LED LIGHTS TURNING FLASHING GREEN,FLASHING
RED OR SHUTTING OFF?
There
experiencingoscillation. This can be attributed to either the quality of
your inputsignal or having your outdoor antenna and indoorantenna too close
together. Please review the following guidelines tohelp resolve this issue:
1. Adjust the direction of the outdoorantenna. If the system is receiving a very high
input signal, you can point your outdoor antenna away from the cellular tower to
reduce the strength of the input signal and therefore, reduce the oscillation.
Alternatively if your system is receiving a very poor quality signal (weak and
unusable signal), you can high the antenna to increase the strength of the input
signal. Sometimes this may require completely repositioning the antenna to a
location where you can achieve a line of site to the tower.
2. Increase the separation between the outdoor antenna and the indoor antenna.
This can be achieved by increasing the distance between the two antennas or by
placing barriers between them.
7 FCC RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instruction
for satisfying RF exposure compliance. This transmitter must not be co‐located or
operating in conjunction with any other antenna or transmitter.This equipment
should be installed andoperated with minimum distance 20cm between the
radiator& your body.
8 Warning and Statement
Note:This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
are
certain
cases
10 / 13
where
your
system
could
be