GreatCo EF67B Manual de instalación y funcionamiento - Página 7

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Chimenea de interior GreatCo EF67B. GreatCo EF67B 9 páginas.

REMOTE CONTROL FUNCTIONS

This appliance can be operated by both remote control and manual buttons located on the side of the fire box. Once the

unit has been properly connected to a grounded electrical outlet, turn on the main power switch located on the right-hand

side of the appliance. A beep should be heard when the power is first switched on.

CAUTION ! The unit's power cord must be connected to a properly grounded and protected 120V outlet.

WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is damaged,

NOTE! To use both remote and manual function the main power switch must be in "ON" position.

THERMOSTAT SETTING

The knob is marked with numbers to indicate the maximum and minimum temperature positions. Start with setting 9 and

to decrease the temperature turn knob to left to a lower setting. To increase the temperature, turn knob to right to a higher

setting.

90237 GER-36 REV A 8-3-12

OPERATING INSTRUCTIONS:

Always use ground fault protection where required by the electrical code.

please call a qualified service technician to inspect and to replace any part of the electrical system

If necessary.

● Operating by Manual Button

MANUAL ON/OFF SWITCH

This switch turns heater on/off, and permits/prohibits use of remote and

panel push buttons.

FLAME BUTTON

Press the FLAME BUTTON to turn on the flame effect, the flame button

can be pressed repeatedly to cycle through the following color and

intensity settings, HIGH FLAME INTENSITY, MEDIUM FLAME

INTENSITY, LOW FLAME INTENSITY, MEDIUM FLAME INTENSITY +

YELLOW BACKLIGHT, MEDIUM FLAME INTENSITY + BLUE BACK

LIGHT and MEDIUM FLAME INTENSITY + MIXED BACK LIGHT.

HEATER BUTTON

Press once turns 750W power on. (Pilot lights illuminated ●○)

Press again turns 1500W power on (Pilot lights illuminated ●●)