Automatic Solutions 603STD+KPAD Manual de instrucciones de instalación - Página 11
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Sistema de interfono Automatic Solutions 603STD+KPAD. Automatic Solutions 603STD+KPAD 12 páginas.
Adjusting Relay time
Press Relay 2 button for 3 seconds, scroll through menu until you see 'ti'. Press OK to select 'ti'
and adjust your relay times. Press OK to select your relay time. Press the right arrow end the
process. Both relays will have the same relay time.
Adjusting time on Handset
Press OK for more than 2 seconds, and then use up and down arrow keys to set hour. Press OK
again to cycle to minutes and adjust. Press OK once more to end the process.
Voicemail
To turn your voicemail ON, press and hold Relay 2 button for 3 seconds, scroll through the menu
until you see 'Re'. Press OK to select 'Re' and adjust your setting to ON or OFF. Press OK to
select. Press the right arrow end the process.
Troubleshooting guide
Q. The unit will not ring the handset.
A. Try re-coding the handset and transmitter as per instructions.
- Check push button wiring to the transmitter with multi-meter.
-Check power cable distance from power adaptor to transmitter is less than 4 metres.
Q. The person on the handset can hear interference on the call.
A. Check cable distance between the speech unit and transmitter. Shorten this if possible.
-Check cable used between the speech unit and transmitter is screened CAT5.
-Check that the screen of the CAT5 is connected to ground in the transmitter as per wiring instructions.
Q. Keypad code not operating the gate or door
A. Check if the corresponding relay indicator light comes on. If it does, then the fault is either a power
problem with excessive cable run, or wiring. If the relay can be heard clicking, then it is a wiring problem.
If a click cannot be heard, then it is likely a power problem. If the light does not activate and the keypad
emits an error tone, then the issue is likely a programming error.
Q. My handset will not recode
Try the process again. If it still does not work, delete the code from the transmitter. To delete code, press
the code button for 3 seconds and release. Then press it 7 times after which a tone should be heard.
Then press another 7 times. Now try re-coding the handset again as per the procedure.
Q. Range problem – Handset works beside the intercom, but not from inside the building
A. Check that the power cable to the transmitter is within guidelines and is heavy enough gauge.
Insufficient power cabling will reduce transmission power! Check that there are not excessive objects
blocking the signal, like large dense shrubs, vehicles, foil lined wall insulation etc. Try to achieve line of
sight between both devices.
Q. No speech in either direction
A. Check CAT5 wiring between speech panel and transmitter. Disconnect, re-strip cables and re-connect
again.
Q. Handset will not charge
A. Try replacing both batteries with equivalent Ni-Mh batteries firstly. It is possible to have a dead cell in
a battery which can prevent both batteries from charging.
-Check for contamination or grease on the charging pins at the base of the handset (gently scratch with
screwdriver or wire wool).
P a g e
| 11