GAI-Tronics ILC-1117 Manual de instalación y uso - Página 13
Navegue en línea o descargue pdf Manual de instalación y uso para Teléfono GAI-Tronics ILC-1117. GAI-Tronics ILC-1117 20 páginas. Titan illuminated crossing telephone
Imprimir página
6.2. Fitting the legend panel.
To fit the legend panel, first ensure that a panel has been correctly printed and
cut to size according to the template above.
Remove the faceplate from the telephone by removing the 4 retaining screws.
Locate the slot behind the window, at the left hand edge when viewing from
the front. The slot is only approximately 1mm thick, and there is a retaining
guide to keep the legend panel aligned correctly.
Gently slide the legend panel into place. Undue force should not be
necessary. Note that the slot is fairly tight to the dimensions above to ensure
correct alignment.
When fully inserted, the edge of the legend panel will protrude beyond the
circuit board to the edge of the gasket, allowing a tab for ease of removal. It
must not overlap the strip of gasket, otherwise the water seal will be
compromised.
7.
Cleaning
Recommended cleaning methods are outlined below:
7.1. Normal Cleaning
For normal cleaning we recommend "Virosol", manufactured by Clover
products.
Carefully follow manufacturer's instructions for storage, handling and use.
7.2. Stainless Steel Push-button
The stainless steel push-button should be cleaned regularly especially if the
telephone is in a marine environment. The stainless steel may show signs of
discolouration or rust – this will not damage the button or impair its
performance but may look unsightly and can be cleaned off using normal
cleaning agents as above. In extreme cases a mild abrasive may be
necessary.
7.3. Graffiti
For graffiti, paint and ink we recommend the use of 3M GR1 graffiti stain
remover.
CAUTION: This is a very aggressive chemical. Pay close attention to the
manufacturer's recommendations for storage, handling and use.
ILC-1117 Titan Illuminated Crossing Telephone
13