Celestial Effects ARIES Beast Distortion Manual del usuario - Página 2

Navegue en línea o descargue pdf Manual del usuario para Equipos de grabación Celestial Effects ARIES Beast Distortion. Celestial Effects ARIES Beast Distortion 2 páginas.

Imprimir página

Celestial Effects ARIES Beast Distortion Manual del usuario

Built like a tank using the best components available, including an all metal powder coated enclosure, CTS pots and Neutrik

jacks. Totally hand built, this pedal will keep you rocking for many years to come.

Celestial Effects™ pedals are hand built and individually tested in Hudson, MA by a company that cares about

quality, durability and value.

VOLUME:

This knob controls the overall volume of the effect when the pedal is in use (not bypassed & LED is ON)

GAIN:

This knob controls the first opamp gain stage and does not utilize clipping diodes. It's fuller and more

open sounding.

DRIVE:

This knob controls the second opamp gain stage and incorporates asymmetrical MOSFET clipping diodes

and is tighter and more compressed. Mixing GAIN and DRIVE results many sonic combinations of true

dirt pedal bliss.

TREBLE:

This knob controls the balance between the bass/mids and treble response of the tone. Raising the treble

above midway will cause a slight attenuation of the overall volume. This is normal. Adjust volume

accordingly. It is non-linear and some may think it is working "backwards". This is normal.

MIDS:

This knob controls middle frequencies response of the tone. Of the three EQ settings, it is the most linear

in sweep control and has very wide in range. The tone stack was designed around the mids control as the

main design consideration in the tone stack addition to the pedal. It's what gives the Aries Beast

Distortion a certain "tone vibe" we set out to achieve.

BASS:

This knob controls bass response of the tone. The majority of the bass knob control is in the first half of

its sweep and it is also dependent of the Mids control setting. Mids and Bass are interactive with each

other. This is normal

NOTE:

The EQ section of the Aries Beast Distortion utilizes a classic analog Fender/Marshall type tube amp

tone stack with Treble, Mids and Bass controls. Adjustments to the EQ settings will have an effect on

your overall volume. For example, raising the treble control will reduce overall output volume as will

lowering the bass and mids controls. This is normal. Output volume will have to be adjusted to

compensate for the EQ changes. The sweeps are not linear and somewhat quirky. This is normal.

Analog circuits are not perfect and rarely linear.

SPECIFICATIONS:

True Bypass Switching

Input impedance: 1M Ohm,

Output impedance: 1K Ohm

Current Draw:

Approximately 22 mA at full ON

POWER REQUIREMENTS:

Internal 9 Volt battery (not included) or any HIGH QUALITY 9 VDC regulated power adapter with a 2.11mm x

5.5mm barrel plug type connector which utilizes a "Center Negative" pin configuration as per the above diagram.

Celestial Effects recommends the Carl Martin Powerjack 9VDC power supply or similar. This power supply is capable

of providing 1000 mA of power and is noise free. The more the capacity of the power supply, the less chance of noise

and hum due to a power supply being pushed to its current capability limits.

CONTROLS