Automatic Technology GDO-6 EasyRoller Manual del usuario - Página 12
Navegue en línea o descargue pdf Manual del usuario para Abrepuertas de garaje Automatic Technology GDO-6 EasyRoller. Automatic Technology GDO-6 EasyRoller 20 páginas. Rolling door openers
También para Automatic Technology GDO-6 EasyRoller: Instrucciones de instalación (2 páginas), Manual de instrucciones rápidas (6 páginas)
Imprimir página
12
GDO-6 EasyRoller
9. Troubleshooting Guide
Symptom
The opener does
not work from the
transmitter
The door does not work
from transmitter or
operate button
The transmitter range
varies or is restricted
The Courtesy light does
not work
The door reverses for no
apparent reason
The door opens but will
not close
®
Home Owner's Manual
Possible cause
Garage door in poor condition e.g.
springs may be broken
The opener does not have power
The battery in the transmitter is flat
Transmitter does not contain
TrioCode
128 Technology
TM
The opener has been put into
"Vacation Mode"
The transmitter button is not
programmed to operate the door.
Door Code LED is flashing yet the
opener is not working.
The opener is disengaged
Variations are normal depending
on conditions e.g. temperature or
external interference
The battery life is exhausted
Position of the transmitter in the
motor vehicle
LED has failed
This may occur occasionally from
environmental conditions such as
areas that are windy, dusty or have
extreme temperature changes.
If Safety beams are installed they
may be partially obstructed.
Safety Beam (Optional Accessory)
not operating correctly
Remedy
Check the door's operation - see
monthly maintenance (Section 10.1)
Plug a device of similar voltage
(e.g. a hairdryer) into the power
point and check that it is OK
Replace the battery (Section 10.6)
Check that the transmitter has grey
buttons and the model number
on the back displays V2. Contact
dealer for support if otherwise.
Turn off "Vacation Mode"
(Section 8.2, step e)
See coding transmitter procedure
(Section 8.1 and 8.6)
Ensure the correct button on the
transmitter is being pressed.
Re-engage the opener
(Section 6.4)
See instructions for correct use of
transmitter (Section 4)
Refer to battery status (Fig 10.3)
Change the position (Section 4)
Contact your dealer for support
Put the door into manual (Section
6.1, take note of the CAUTION) and
contact your dealer.
Ensure the beam path is not
obstructed. If continues, contact
your dealer.
Contact your dealer for support