Hickory 5.5 E Manual de instalación - Página 9

Navegue en línea o descargue pdf Manual de instalación para Horno de convección Hickory 5.5 E. Hickory 5.5 E 15 páginas.

1.7

Spit Drive Mechanism

This unit is equipped with a planetary motion spit drive system. This means that each spit is

turning upon its axis at the same time that they turn about the center shaft. When the motor

switch is turned to on, the disks and the spits will begin to turn. Insure that the mechanism

turns smoothly when testing the unit.

Aluminum Drive

Disk

Spit

Before cooking, it is imperative that the center shaft be covered and protected with aluminum foil. This will

prevent fats from carbonizing on the shaft, making the removal of the aluminum disks much easier in the

future. If the shaft is not protected, it may eventually be impossible to remove the disks should there be a

problem in the spit drive mechanism.

The driven and the stationary drive gears are located behind the aluminum drive disk. These can be

viewed by taking out the removable aluminum disks. The driven gears and the stationary gear should

be viewed once a week to check for fat or carbonization build-up. Any fat or dirt should be cleaned

off since a build-up will eventually damage the drive system.

Center Shaft

4900 Westside Avenue, North Bergen, New Jersey 07047

Tel: [201] 223-0050 Fax: [201] 223-0950

Hickory Industries, Inc.

N/5.5E Installation 8/5/97

Page 9 of 15