GAI-Tronics Clean Phone 295-702F Manual - Página 10

Navegue en línea o descargue pdf Manual para Teléfono IP GAI-Tronics Clean Phone 295-702F. GAI-Tronics Clean Phone 295-702F 18 páginas.

Clean Phone

VoIP Telephones

Model 295-702W

The mounting and wiring instructions are as follows:

1. Remove the front panel from the back box.

2. If using Power-over-Ethernet, with no optional inputs or outputs: place the bushing around the

Ethernet cable so that it is located approximately 5 inches from the end of the cable. Snap the

bushing closed and insert it into the double D hole in the back box (see Figure 4 and Figure 8).

3. If using local power or optional inputs or outputs: route the cables through the D hole in the bottom

of the back box (see Figure 4 and Figure 8).

4. Position the back-box so that it is level on the wall in the desired location.

5. Use the back box as a template to drill the lower right and upper left corners holes and secure the

back box with screws.

6. Drill the remaining holes and completely secure the box with the remaining screws.

7. Plug in the Ethernet cable and connect all other optional cables (see the Field Wiring section).

8. Perform the initial programming of the telephone (see the Programming section).

9. Align the front panel of the Clean Phone

10. Press the panel in firmly and push it downward to seat it in the slots.

: The Model 295-702W VoIP Telephone is designed for general wipe down cleaning and to prevent

OTE

collection (internally and externally) of particulate matter.

P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-470G.docx

05/19

with the four slots in the back box.

Figure 8. Mounting the Model 295-702W

Pub. 42004-470G

Page 8 of 15