AirCycler g2-k Manual de instalación y uso - Página 7

Navegue en línea o descargue pdf Manual de instalación y uso para Termostato AirCycler g2-k. AirCycler g2-k 11 páginas.
También para AirCycler g2-k: Manual de formación (20 páginas), Manual de pruebas de instalación (2 páginas), Manual de pruebas de instalación (2 páginas)

2.2 CALCULATED TIME SETUP

2.2.1 SETTING NUMBER OF MINUTES PER HOUR OF SUPPLIED AIR FLOW REQUIRED

Enter the minutes per hour that you require fresh air to be brought into the home. Factory

default is 20 minutes.

Press MODE to advance to the next setting

For installations without the FanConnect™ switch, go to section 2.2.3.

2.2.2. SETTING MINUTES OF EXHAUST FAN RUN TIME REQUIRED

Enter the desired minutes/hour you want the exhaust fan to run. Factory default is 20

minutes per hour.

If the FanConnect switch is not detected, make sure it is in the OFF position.

See Appendix B for troubleshooting.

2.2.3 SETTING OPERATION HOURS

If the user does not want the ventilation system to run constantly, you can set ON time

and OFF time. Factory default is ON.

If you are not setting an ON and OFF time, continue to section 2.2.5. If you enter YES, the AirCycler® g2 will prompt you

to enter the hour you would like the ventilation to begin and the hour you want it to end followed by the current time.

Set the hour you want the ventilation to START. Press MODE to advance to the next setting.

Set the hour you want the ventilation to STOP.

Press MODE to advance to the next setting.

2.2.4 SETTING CURRENT TIME

Enter the current time. Press MODE to advance to the next setting.

If you are not connecting a FanConnect™ switch, continue to section 2.2.6.

2.2.5 EXHAUST FAN DELAY TIME

Set the desired length of time you would like the bath fan to run after the FanConnect™

has been turned off. Factory default is 10 minutes.

Press the DOWN arrow until the countdown reaches 0 then SL (SL= slave mode) In slave

mode the exhaust fan runs anytime the central fan is running with the fresh air damper

open. Slave mode will provide a "balanced" mode of operation.

2.2.6 CALCULATED TIME SETUP IS COMPLETE

Setup is complete. The AirCycler® g2 will now return to normal operation.

See Section 3 for normal operation.

AC DOC 8.5

REV 11/21/2014