Dynalabs DYN-IS-5 Manual del producto - Página 4
Navegue en línea o descargue pdf Manual del producto para Pulverizador de pintura Dynalabs DYN-IS-5. Dynalabs DYN-IS-5 15 páginas. 5 n inertial shaker
Imprimir páginaAll rights reserved. Reproduction or issue to third parties in any form whatsoever is not permitted without written authority from the proprietors.
1) Introduction
The inertial shaker (DYN-IS-5) is used for small structures requiring
excitation in low frequency bands. The shaker is directly connected to the
structure and the inertia motion of the shaker mass provides the necessary
forces to the structure. The shaker has a small, lightweight design that
provides high mobility. For this reason, it is suitable for use as a portable
shaker.
2) General Information
2.1) Unpacking and Inspection
Dynalabs products provide adequate protection for undamaged products to be
transported. Document the damages that occur indirectly during the transport
and contact the customer representative. Check all components of the shaker.
If there is a defect, please contact us.
2.2) System Components
DYN-IS-5 has the following components:
- Electrodynamic Shaker
- Amplifier (DYN-SA-150)
- Power Adapter
- Signal Cable
- Wrench
- Ground Cable
- User Manual
2.3) Theory of Operation
DYN-IS-5 is an electromagnetic actuator. Electromagnetic actuators are
basically a voice coil consisting of magnet and coil. The moving element can
be a coil or magnet depending on the design requirements. The moving
element is usually suspended by an elastic spring. DYN-IS-5 has a stationary
coil (drive coil) whose current is controlled to produce vibration. The
stationary magnetic field is produced by a magnet.
4