GAI-Tronics 370-901 Manual - Página 9

Navegue en línea o descargue pdf Manual para Equipos de grabación GAI-Tronics 370-901. GAI-Tronics 370-901 19 páginas. Sp2 to page/party bridge

Imprimir página

Model 370-901 SP2 to Page/Party

Mute Connection—P5

The muting conductor of the Page/Party

Terminal block P5 provides a dead ended termination for the muting conductor of the Page/Party

cable (see Figure 4):

1. Install a ferrule onto the end of the orange wire.

2. Connect the wire to pin one on pluggable terminal block P5.

3. Connect the pluggable terminal block to terminal block P5.

Power—P1

The SP2/Page/Party

Bridge operates from a 120/230 V

ac, 50/60 Hz power source. AC power is connected at

terminal block P1:

1. Pull the cable from the power source into the

enclosure.

2. Install ferrules onto the wire ends.

3. Connect the line, and neutral, conductors to the

pluggable terminal block (see Figure 4 and Table 6).

4. Connect the pluggable terminal block to terminal

block P1

Close the Enclosure

1. Reconnect the front cover to the rear enclosure by pushing the hinge pins on the front cover into the

holes on the left side of the rear enclosure until a click is heard.

2. Rotate the front cover to close the enclosure.

3. Install and tighten the four screws on the front cover.

Configuration

SP2 to Page/Party

Bridges are configured using the GUDA (GAI-TRONICS Universal Device

Application) software. Install the GUDA software and run it to configure Page/Party

1. Launch the GUDA application by double clicking the GAI-TRONICS Universal Device Application

shortcut from the start menu.

2. Choose the network interface to perform the discovery.

P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-525A.docx

08/18

Bridge

system cable has no function in the SP2 to Page/Party

Table 6. AC Power—P1

Label

Description

P1-1

LINE

P1-2

NEUTRAL

P1-3

bridges as follows:

Pub. 42004-525A

Page 7 of 16

Bridge.

system

ac hot

no connection

neutral