Automation Direct DL06 Primeros pasos - Página 5
Navegue en línea o descargue pdf Primeros pasos para Controlador Automation Direct DL06. Automation Direct DL06 7 páginas.
Imprimir páginaInstalling the Option Modules
Before installing the option module in the DL05 option slot or the DL06 option slots set the
necessary jumpers and/or dip switches on the module. Refer to the chapter(s) that pertains to
the module(s) being installed.
Remove the Slot Cover
The first step in installing the option module is to remove the protective option slot cover.
Remove the cover by squeezing the pinch tabs and lifting the cover off.
Insert the Module
Now, insert the module into the open slot. Locate the module so the printed information
is oriented in the same direction as the markings on the PLC. Be careful to align the female
connector on the printed circuit board of the module with the male connector on the PLC
mother board. Press the module into the slot until the front of the module is flush with the
front of the PLC. Install the remaining modules in the DL06. Once the modules are in place
the PLC is ready to be programmed.
WARNING: Power to the PLCs must be disconnected before inserting or removing a module. Failure to
disconnect power could result in serious damage to a module, the PLC or both.
Option Module
Slot Covers
G
LG
0V
Y0
Y2
C1
Y5
Y7
Y10
Y12
AC(L)
AC(N) 24V
C0
Y1
Y3
Y4
Y6
C2
Y11
Y13
OUTPUT: 6–240V
50 – 60Hz 2.0A, 6 – 27V
2.0A
PWR: 100–240V
50–60Hz
Y
0
1
2
3
4
5
6
7
10
11 12 13 14
15 16
17 20 21 22
X
INPUT: 12 – 24V
3 – 15mA
C0
X1
X3
X4
X6
C2
X11 X13 X14
X16
C4
X0
X2
C1
X5
X7
X10 X12
C3
X15 X17 X20 X22
DL05/06 Option Modules User Manual; 7th Ed. Rev. C
Chapter 1: Getting Started
C3
Y15
Y17
Y14
Y16
N.C.
40VA
D0–06DR
23
X21
X23 N.C.
N.C.
PORT1
PORT2
Pinch Tabs
PWR
RUN
CPU
TX1
RX1
TX2
RX2
TERM
RUN STOP
1–5