Celestron 21045 Manual de configuración rápida

Navegue en línea o descargue pdf Manual de configuración rápida para Telescopio Celestron 21045. Celestron 21045 2 páginas. Powerseeker series
También para Celestron 21045: Manual de instrucciones (10 páginas), Especificaciones (4 páginas), Folleto y especificaciones (4 páginas), Especificaciones (2 páginas), Manual de configuración rápida (2 páginas), Manual de configuración rápida (2 páginas)

PowerSeeker 114

Item# 21045

Your PowerSeeker 114 includes: optical tube w/

tube rings attached; tripod with center leg brace;

equatorial mount; 2 eyepieces; a 3x barlow lens,

finderscope; 5 lb. counterweight; counterweight bar;

two slow motion cables; eyepiece accessory tray;

The Sky Level 1 software, documentation including

an owner's manual.

All three legs should be the same length to

provide a level platform for the telescope.

Locate the equatorial mount and place the

base of the mount through the hole in the

center of the tripod mounting platform.

Celestron Technical Support: 310

To set up the tripod, spread the legs outward

until they are fully extended and push down

center leg brace. Extend the center portion of

each of the three tripod legs down 6-8".

Place the accessory tray on top of tripod's

center leg brace. Thread the tray into the

threaded hole in the center of the leg brace.

From underneath the tripod mounting platform,

thread the mounting bolt with washer into the

threaded hole on the bottom of the equatorial

mount.

Questions or Problems with Set-up?

CONTACT:

Quick Set-up Guide

Use the three tightening screws located at the

bottom of each leg to secure the extended legs

in place.

Properly assembled, the accessory tray should

appear as pictured above.

Thread the latitude adjustment screw into the

equatorial mount until it is touching the inside

of the mount.

803

5955