Celestron 21049 Manual de configuración rápida - Página 2

Navegue en línea o descargue pdf Manual de configuración rápida para Telescopio Celestron 21049. Celestron 21049 20 páginas. Powerseeker series
También para Celestron 21049: Manual de instrucciones (16 páginas), Configuración rápida (2 páginas), Especificaciones (2 páginas), Manual de configuración rápida (2 páginas), Manual de configuración rápida (2 páginas)

Locate the counterweight bar and counterweight. Slide the

counterweight half way down the counterweight bar.

The cable should attach to the Right Ascension axis and the other

cable attaches to the Declination axis. Tighten the screw to secure

the cable in place.

Place the telescope tube back into the bottom half tube rings, hinge

the upper halves over the telescope tube, and secure the latch knobs

holding the telescope tube in place. Make sure the focuser end of the

telescope is be over the counterweight assembly.

Loosen the set screws on the focuser so they do not obstruct the

inner diameter of the focuser. Remove the plastic cap covering the

end of the focuser.

For additional magniﬁ cation, you can use the included 3x Barlow

Lens. Place the Barlow lens in the focuser in place of the eyepiece.

Remove the cap from the Barlow lens.

2 | E NG LISH

HOLD

Holding the counterweight in one hand, line up the counterweight

bar with the mount. With your other hand, turn the counterweight

bar until it is fully seated. Tighten the counterweight locking screw to

hold the counterweight in place.

Remove the tube rings from the telescope tube by loosening the latch

knobs on the sides of each ring. Then remove the two black wingnuts

on the bottom half of each tube ring.

Remove the knurled nuts on the threaded posts at the focuser end

of the telescope tube.

Insert the barrel of the 20mm eyepiece into the focuser and tighten

the screws.

Next, insert the eyepiece into the Barlow and tighten the set screws

to secure it in place.

Slide the chrome end of the slow motion control cables onto

equatorial mount gear shaft. Be sure to line up the set screw over the

ﬂ at spot on the shaft. Tighten screw to secure in place.

Align the holes on the bottom half tube rings with the holes on

the mount and secure them in place with the black wing nuts

removed in step 14.

Locate the ﬁ nderscope and remove plastic caps on front and back

of lens. Orient the ﬁ nderscope so that the glass window is facing

towards the front of the tube as shown here. Place ﬁ nderscope over

the posts on the tube and tighten it down with the knurled nuts.

Remove the lens cap from the front of the telescope. To observe, look

through the eyepiece as shown above. Focus the image by turning

the knobs below the focuser.