Celestron 22405 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Telescopio Celestron 22405. Celestron 22405 12 páginas.

Imprimir página

THE STARPOINTER PRO FINDERSCOPE

Your Inspire telescope comes with a StarPointer Pro Finderscope

that you will use as a sighting tool when aiming the telescope at

a target.

To install the ﬁ nderscope:

1. Slide the ﬁ nderscope bracket into the dovetail slot on the

telescope on the top of the focuser. The large window on the

ﬁ nder should be facing the front of the telescope.

2. Secure the bracket by tightening the setscrew on the

dovetail slot.

The StarPointer Pro uses a CR-2032 button battery. To change

the battery, turn the StarPointer over. The battery compartment is

located in the center of the on/off/brightness switch. Use a coin

in the slot on the cover to unscrew the cap counter-clockwise until

the cap comes off. Insert the new battery with the Positive (+) side

facing upward and screw the cover back on. If your StarPointer

Pro does not immediately turn on, open the battery compartment

to remove the small plastic disk that lies between the battery

and the battery cover. This is used to prevent the battery from

accidentally discharging during shipment.

If you are going to store your telescope for a long period of time,

it is best to remove the battery to prevent accidental corrosion.

THE FLASHLIGHT

The Inspire mount comes with a built-in red LED ﬂ ashlight located in

the central hub of the mount's left and right axis. To remove it from

the mount, simply grab the top and pull straight up.

To install the single AA battery:

1. Unthread the red lens at the end of the ﬂ ashlight.

2. Slide the ﬂ ashlight out of its protective cover.

3. Unthread the cap on the back of the flashlight to expose the

battery compartment.

4. Insert the AA battery into the ﬂ ashlight, positive (+) side ﬁ rst

and replace the compartment cap.

5. Slip the ﬂ ashlight back into its protective housing and thread

the red lens to lock it in place.

To turn on the ﬂ ashlight, simply depress the rubber covered button on the back.

The ﬂ ashlight was designed to be stored in the mount and can actually be used in this position. Turn on the light and it will provide a

diffused red glow onto your accessory tray, making it easy to identify your eyepieces and ﬁ lters in the dark.

NOTE:

Don't forget to turn off the ﬂ ashlight when it is not in use. If you are going to store your telescope for a long period of time, it is best to remove the battery to prevent accidental corrosion.

Horizontal

Adjustment Knobs

On/off/brightness switch

Battery Cover

Vertical

Adjustment Knobs