Gaines Janzer Double Post Instalación y montaje - Página 2

Navegue en línea o descargue pdf Instalación y montaje para Equipamiento postal Gaines Janzer Double Post. Gaines Janzer Double Post 2 páginas.

Attach one each of the Arm Clips to each side of the post (two screws per clip) using the two lower

centered holes on post sides. The slot on the Arm Clip should be on the bottom. DO NOT over

tighten. Now attach each Post Arm by sliding it over the Arm Clip, with the long side of the Post

Arm against the post. Push down firmly until the Post Arm is flush with the post. (Note: If the

Post Arm will not start over the top of the clip, you can use a pair of pliers to slightly bend the top

of the clip away from the post until the Post Arm fits over the Arm Clip in a snug manner.)

Now take a Mounting Plate and set it on top of one of the Post Arms, lining up the slots on the

bottom of the plate (center) with the holes on the Post Arm, and lining up the slots on the short

angle side with the two holes in the post. Take two of the Phillips screws and put them through

the Screw Cover Retainers and start them loosely into the post. Take two more Phillips screws

with fender washers and start them loosely into the Post Arm. Tighten all four screws securely

(DO NOT over-tighten). Put Screw Covers over the Screw Cover Retainers on the post. Repeat

this procedure for the other side.

Now attach the Finial to the top of the post. The square base of the Finial will press fit into the

open square top of the post. If desired, apply clear exterior silicone adhesive (available at your

local hardware store) to the inside walls of the post before inserting the Finial.

At this point, please follow the instructions included with your Janzer Mailboxes to attach the

mailboxes to the post.

Thank you for purchasing this product. Should you have any questions, please call Gaines Customer Service at 858-486-7100.

Gaines Manufacturing, Inc.

San Diego, CA

www.gainesmfg.com

Page 2 of 2