Gaines Keystone Series Instrucciones de instalación y montaje

Navegue en línea o descargue pdf Instrucciones de instalación y montaje para Mobiliario exterior Gaines Keystone Series. Gaines Keystone Series 2 páginas.

Imprimir página

Thank you for purchasing a Keystone Series Deluxe Post. We're sure you'll enjoy your new post for many

seasons to come. If you have any questions about how to install or use this post, if you need any assistance

during installation, or if you require replacement parts, please phone us directly at (858) 486-7100, M-F

7:30am-4:30pm (Pacific).

Tools needed:

½", and

7/16",

9/16

Socket drive or wrench

Post Installation

A. Determine the proper height of the mailbox above ground. (Check with local postmaster

for specific details. The height from road level is typically between 40"-44").

appropriate amount of post to bury subtract your desired height from 55. The result will be the length of post that

should be buried (Example: Desired 40" mailbox height would require 15" of post burial. (55"-40"= 15")

B. Locate site for the mailbox and dig a 12" diameter hole. The depth of the hole will

depend on your desired height of mailbox. Note: If you desire additional length or

stability, the Keystone Deluxe Post is designed to slide over a wood 4"x4" post (available

at your local hardware store). Make sure the hole is set back from the road such that the

distance from the curb to the mailbox door meets post office requirements, normally

between 6 and 8 inches.

C. Place the post into the hole (two larger holes should be on the top) with the end resting

on the bottom of the post-hole and the holes in the post facing to either side. (The front

face of the post should not show any holes).

D. Use a spirit level to set post to true vertical position in the post hole. Be sure to align the

face of the post with the driveway, sidewalk, walkway, roadway, etc.

E. Pour concrete completely around the post, taking care to maintain the level of the post.

Attach Beam and End Cap to Post

NOTE: If you purchased a Decorative Post Cuff, please install the Cuff before proceeding.

A. Determine which side of the post (left or right) the beam is to be mounted on.

B. Install Bushings into the two holes on the selected side with long end into post holes

(see diagram).

C. Position Beam holes over short end of Bushings. (Bushings should now be installed

between beam and post.)

D. Locate washer and 5" bolt. Place washer on bolt and insert bolt through the top of the

two mounting holes. The bolt should pass through the mounting face of the beam and all

the way through the opposite side of the post.

E. Match one of the threaded holes in the End Cap with the protruding bolt inserted in

previous step.

F. Turn machine bolt 2 or 3 turns to loosely hold Beam and End Cap in place in preparation

for installation of the second 5" bolt. Be careful not to move parts as excessive movement

can damage paint finish.

G. Visually align Beam and End Cap. Using wrench or socket drive, securely tighten both

bolts. DO NOT OVER-TIGHTEN.

Keystone Series

Installation and Assembly Instructions

#2 Phillips head

screwdriver

Deluxe Post (KDX)

Hardware:

(Not to scale)

To determine the

800-824-9985

Height

from road

per local

postmaster

Set back

- typically

from road,

40"-44".

typically

6"-8".