Activeforever SnowJoe Plus 322P Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Soplador de nieve Activeforever SnowJoe Plus 322P. Activeforever SnowJoe Plus 322P 8 páginas. Snow thrower snowjoe

Imprimir página

2. Using an open end wrench, loosen the nut between the

body and the rotor (counterclockwise). Hold the loosened

nut and turn the outer body bolt counterclockwise. Remove

nut, bolt, and washers (Figure 9).

Figure 9

C. Bolt

D. Flat washer

E. Flat washer

F. Nut

3. Pull out the rotor starting at the left side (Figure 10).

Figure 10

G. Rotor

Note: You may need to pull out the rotor using both hands.

Please wear gloves to prevent injury.

4. Install the new rotor reversing the above steps.

Storage

CAUTION: Store electrical appliances in a locked area away

from children and unauthorized users.

1. Before storing, inspect the entire appliance for any damaged

or worn parts. Check connections and screws and tighten

if necessary. Check blade condition. Examine the extension

cord and its plug for excess wear or damage, and replace

if warranted.

2. Store the snow thrower safely out of harm!s way and prevent

access by unauthorized users, preferably by placing in a

locked cabinet. Keep away from dust and humidity by

loosely covering with a tarp and using de-humidifying

products as conditions warrant.

3. Keep the extension cord with the appliance. If the entire

appliance is locked away, keep the key in a container or

plastic bag, tied or taped to the handle so it isn!t lost. If the

appliance isn!t locked up, it is advisable to store the key in a

separate secure place to prevent unauthorized use.

Service and Support

If your Snow Joe 322P electric snow thrower requires service

or maintenance, please call 1-866-SNOWJOE for assistance.

Model and Serial Numbers

When contacting the company, reordering parts, or arranging

model and serial numbers, which are found on the decal on the

lower tube. Copy these numbers into the space provided

below.

Please record the following numbers from the housing or handle of your

new product:

Model #:

3 2 2

Serial #: