Celestron ASTRO FI 22202 Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Telescopio Celestron ASTRO FI 22202. Celestron ASTRO FI 22202 12 páginas. 90 mm refractor/102 mm maksutov/130 mm newtonian

Imprimir página

1. What's in the Box

IMAGING WITH YOUR SMARTPHONE

Now that you have observed with your telescope, the next

step is taking a picture of what you are seeing. Your telescope

has a smartphone adapter built right into the lens cap.

To use this feature:

1. Start by pulling the orange plug out of the camera opening in

the lens cap. You can do this by pulling on the orange rubber

lanyard located on the inside of the lens cap. The plug should

pop right out. The plug and lanyard can be stowed out of the

way by pressing the lanyard into the retaining clip located on

the back of the lens cap next to the eyepiece holder.

2. Turn the cap so that the outside of the cap is facing upward.

Lift the bungee straps and slide your smartphone between the

straps and the lens cap so that the camera is looking through

the camera opening. The straps should give plenty of tension

to hold the device against the cap and the black silicon ring will

give enough friction to prevent the phone from sliding around.

HINT:

Depending on the design of your smartphone, the camera may be in the middle of

the device or in one corner. You may want to change the angle of the bungee straps

to better secure the phone. There are eight different anchor points to choose from

around the edge of the lens cap. Simply reposition them to different anchor points to

achieve the best results.

3. Turn the cap over and make sure your camera lens is centered

in the opening in the lens cap. The better you have this centered,

the easier it will be to take images through the telescope.

4. Loosen the set screws located on the eyepiece holder on the

inside of the lens cap. Place the black portion of the eyepiece

into the eyepiece holder and tighten the screws to secure the

eyepiece in place.

5. Now take the lens cap with the phone and eyepiece attached

and insert the chrome barrel of the eyepiece into the diagonal

on the back of the telescope's focuser. Secure it in place by

tightening the set screws on the diagonal.

6. Activate your camera app on your smartphone and adjust the

focus, just as you would the eyepiece, this time using the image

that appears on your screen.

NOTE:

Make sure you turn the phone's ﬂ ash off.

7. When the image appears sharp snap your image.

It is best to try this in the daytime ﬁ rst, then, once everything is setup

correctly, take it outside and try shooting the Moon. Once you have

practiced and are comfortable using the 20 mm eyepiece, try using

the camera adapter with the 10 mm eyepiece for higher magniﬁ cation.

| ENGLISH

A s t r o F i T E L E S C OP E