Hiddn coCrypt B Selfkey Manual del usuario

Navegue en línea o descargue pdf Manual del usuario para Módem Hiddn coCrypt B Selfkey. Hiddn coCrypt B Selfkey 5 páginas.

Imprimir página

User Manual

Please read through this guide thoroughly

before powering up your hiddn coCrypt B USB

device the first time

This guide describes the first time set-up procedure (sections A and B) for the 2-factor coCrypt B USB device

followed by a description (section C) of how to use coCrypt in daily operation. The following sections gives

information about name change, PIN change etc. You may also find additional or updated information at

www.hiddn.no/support.

A. Insertion of the Keycard Break-out Module (SIM card):

Remove the back cover and pull out the card holder, using a small screw-

driver, a tiny pin, your nail or a similar tool.

2. Remove the keycard break-out module (SIM card) from your keycard and insert it

into the holder as shown below. Verify that the card is marked with "B". Make sure

you insert it with the active (golden) area facing towards the top area (display area)

of the coCrypt B and note the cut-out corner. See the pictures below:

B. First Time Setup

Press

to power on. The display shows "coCrypt B". Insert your coCrypt B into a USB port on

the PC. If necessary, use the 20 cm extension cable included in the box.

coCrypt B until you have reached point 5 in this section.

2. Wait until the display shows "Initialize [Y/N]" (May take up to 60 seconds).

3. Press

to answer Yes. The display will show "Initialize [Y/N] Y". Press Enter

press N

you will get the message "Please restart". Remove the coCrypt B from the

computer and go back to point 1 in this section to restart the operation).

4. The display shows "Do NOT unplug". Make sure the device does not lose power

the device from the computer and do not turn off the computer)

"Init OK, restart". This may take several minutes.

5. Restart hiddn coCrypt B by removing it from the PC and then reinsert it.

6. The display shows " New PIN". Key in your chosen PIN code. If you type an error, undo the typo

by pressing

. When finished press Enter

must have at least 7 digits and at least one digit must be offset by 2 or more compared to the

preceding one. (Examples: "1-2-3-4-5-6-7", "0-0-0-1-0-0-0", "4-3-2-1-2-3-4", "7-6-5-4-3-2-1", "0-

0-0-0-0-0-0", "1-1-2-2-3-3-4-4" are all non-acceptable while "0-0-0-2-0-0-0" and "9-7-6-5-4-3-1"

are acceptable).

7. The display shows "Confirm". Reenter your new PIN code and press Enter

display now shows "SD ready" and will also show "USB locked" since the system in this coCrypt B

version is set up with the extra USB connection logically blocked from use. ( The display will show

"PIN too weak" and then "New PIN:" in case the chosen PIN code does not meet the system

requirements. In that case go back to step 6 and reenter another PIN code).

CC01-UM-B01-02.12-ENG-01.12.16

coCrypt B

WARNING:

Do NOT activate this product if the security

and/or product labels have been removed or

cut off prior to opening the box

. It is a system requirement that the PIN code

Selfkey

DO NOT unplug the

. (If you

(do NOT unplug

until the display shows

once more. The