Automation-at-Home X10 Manual - Página 2

Navegue en línea o descargue pdf Manual para Controlador Automation-at-Home X10. Automation-at-Home X10 2 páginas.

Automation@Home

www.automation-at-home.com

Operation:

• Face the Infra-Red Controller towards the infra-red

appliances e.g. air-conditioner, curtain motor, TV, etc

• Use any X10 Transmitter/Controller to trigger the

transmission of the infra-red command.

• For example, if the Infra-Red Controller has been

programmed with the infra-red On/Off command of an

air conditioner unit, and it has been pre-set with an X10

address of 'C1', then simply transmit an X10 signal 'C1

On' to turn on the air-con or 'C1 Off' to turn it off.

• You can also use the button on top of the Infra-Red

Controller to trigger the infra-red transmission. Press it

once and the 'Red Indicator' turns on and press it again

to turn on the 'Green Indicator' corresponding to the

Infra-Red 'Turn On' and 'Turn Off' respectively. (Only

valid for the first X10 address)

Trouble Shooting:

• This product is applicable for 38KHz infrared command. It

supports the command length under the 250ms. Other

commands are not available for the product.

• After programming the infra-red commands, you still cannot

control the appliance with the X10 command, delete that

particular X10 address's IR commands and re-program

again.

• When green light flashes when learning the infrared

command, this means that the learning process has failed.

Please try again. If the learning process continues to fail

three times, please clear the memory and start the learning

process all over again.

• If the product still cannot learn certain commands, that

means the commands is not supported. Please contact your

dealer for assistance.

Manual

NO. X10-3011US