Gainsborough G+ LOCKSET Manual de instrucciones de instalación - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Por cerraduras Gainsborough G+ LOCKSET. Gainsborough G+ LOCKSET 8 páginas. G+ series for the apex electric locksets and volt electric locksets

Imprimir página

Task 3

Turn key clockwise

Inside

door face

Rotor

Make sure the

connectors are

pushed together

Turn key clockwise

NOTE: The mounting plate must first be removed from the

inside faceplate.

• Insert key and turn clockwise.

• Remove the mounting plate.

• The key can now be turned back to the vertical position

and removed.

• The rotor is pre-installed onto the mounting plate. The rotor

must be positioned such that one notch faces upwards, and

the other notch faces towards to latch side (door opening).

• Mount and hold the outside faceplate onto the outside

door face. Assemble the mounting plate to the outside face

plate. Make sure the connector wires pass through the large

rectangular hole in the mounting plate and that the spindle

engages the outside lever.

• Fit 2 mounting screws from KIT B and tighten.

NOTE: If "KIT B" contains 2 length of screws then use the

following guide:

• For doors up to 40mm thick use the 2 "short" screws.

• For doors 40mm and over use the 2 "long" screws.

• Insert key into the inside faceplate and turn clockwise.

Leave key in this position.

• Assemble the connector from the Battery Box with the

connector on the faceplate. Make sure they are firmly

pressed together.

NOTE: Do not let go of the faceplate or allow the faceplate

to "hang" from the wires.

• Hold the faceplate flush against the door face making sure

that wires from the Battery Box are not trapped. The key can

now be turned back to the vertical position and removed.

The faceplate is now temporarily secured and will not fall

if let go.

• Fit 4 mounting screws from KIT C and tighten.