Gainsborough Z5R Series Instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación para Por cerraduras Gainsborough Z5R Series. Gainsborough Z5R Series 2 páginas.

Installation Instructions for Z6R & B6R Series Dummy Lever

Step 1.

• Fold Template where indicated.

• Position template on door edge at desired height.

• Firmly hold template & mark 5 hole centres (4 off 9mm

& 1 off 25mm) at required backset.

Note: 25mm hole 10mm deep only.

• Drill Pilot holes - suggest 3mm, then enlarge (4 off) 9mm

holes from both sides of door.

• Drill (1 off) 25mm hole 10mm deep on side of door dummy

leverset will be fitted.

Step 2.

Install lever assemblies to door: Z6R & B6R Series Dummy Lever

• Remove rosette cover (1) from lever assembly.

• Place dummy lever assembly (2) with latch alignment posts (3) against door face.

• Place dummy plate (4) into position, on back of door.

• Fasten lever assembly & dummy plate together with screws (5) & tube nuts (6)

provided: Use long screws for thick doors and short screws for thin doors.

• Install screws (5) from dummy plate side into the vertical tube nut holes (8) of the

dummy leverset under-rose. Then tighten both screw heads.

• Reapply rosette cover (1) to under-rose by pushing the cover over the rubber ring

until flush with door.

Gainsborough Hardware Industries Limited,

Melbourne, Australia. A.B.N. 25 004 792 269

www.gainsboroughhardware.com.au

55A1DOC04BT1

AT 000

JUN '12

FOLD HERE

9mm hole

25mm hole

x 10mm deep

Important Note:

Don't drill this hole

through the door.

Installation template

for dummy applications