Hideaway Soft Close Series Instrucciones de instalación

Navegue en línea o descargue pdf Instrucciones de instalación para Accesorios de lavandería Hideaway Soft Close Series. Hideaway Soft Close Series 2 páginas. 60l base mounted laundry hamper
También para Hideaway Soft Close Series: Instrucciones de instalación (4 páginas)

Imprimir página

Hideaway

Installation Instructions

60L Laundry Hamper

Important Installation Information:

AT ALL STAGES OF THE INSTALLATION ENSURE THE SPRING CARRIER ON THE

RUNNER IS ENGAGED!

Before you close the unit ensure the spring carrier is loaded on your soft close runner.

Failure to do so may cause damage to your runners.

Figure 1a - Demonstrates the spring carrier in the engaged position. This is the correct

positioning and the laundry hamper is ready to be closed and used.

Figure 1b - Demonstrates the spring carrier in an disengaged position. To move into

engaged position, move the white spring carrier along its runner until it clicks into location

demonstrated by arrow in Fig 1b. Alternatively, if discovered after installation is complete

then you may also try the following: push the drawer to the firmly closed position. Push the

disengaged side of the door firmly until you hear a click from the runner re-engaging. The

runner should now close fully under normal operation and be positioned as shown in Fig 1a.

Step 1 - Unpack Hideaway Bin

• Remove all polystyrene.

• Remove the hamper.

Step 2 - Remove the door bracket

• Remove door bracket from the brown box found inside the hamper and set aside

until step 5.

• NOTE: VERY IMPORTANT - Do not remove the runners from the top mounting panel.

• See (fig 2) to identify unit parts.

Step 3 - Install your bin within your cupboard / carcass (top mounting)

• Position the top mounting panel inside, beneath your carcass / shelf.

• NOTE: VERY IMPORTANT - Set the top mounting panel back 2mm from front of carcass.

• Position in the centre of the carcass. Mounting holes are located in the top mounting

panel for fixing. Secure the top mounting panel into place with the Surefix screws

and washers provided. Any additional mounting holes added by the installer will null and

void warranty.

Step 4 - Install your bin within your cupboard / carcass (side mounting)

• Your unit has side mounting dimples, as shown in fig 2 & 3. If side mounting, the internal

space of the cabinet must be within the advertised width.

• The side mounting dimples are to be secured with the Surefix screws and washers provided.

Step 5 - Door bracket (fig 4, 5)

• Align the door bracket (fig 6) to the collar (fig 7) and lightly tighten in place using the

nuts provided.

• NOTE: Lightly tighten nuts to allow fixing of door front. (Refer fig 4 & 5)

Soft Close Range

Runner engaged - correct

Runner disengaged - incorrect

Top mounting panel

Side mounting

dimples

Runners

Door bracket

Top mounting holes

Side mounting holes

Collar