Hideawaybeds alpha bed SBF Manual de instrucciones de montaje - Página 11
Navegue en línea o descargue pdf Manual de instrucciones de montaje para Mobiliario interior Hideawaybeds alpha bed SBF. Hideawaybeds alpha bed SBF 18 páginas. Steel bed frame
Imprimir páginaSTEP 4: Attach Bed Cabinet Securely to Wall
Hints:
If the room is carpeted you may raise the kick up to 1/4" (7mm) to clear the
carpet. More than 1/4" (7mm) will obstruct the operation of the bed.
You may or may not wish to remove the Base Board to allow the Bed Cabinet to fit
flush against the wall. If you do remove the Base Board, save for later trim and
replacement. If you do not wish to remove the Base Board, you may use a shim or filler
strip of the same thickness at the top between the cabinet and the wall.
1. Place cabinet against wall. Make sure the cabinet is level and square. Measure
diagonally to be sure of square. Bed will not operate if cabinet is not square. Check
also for square from front to back as well as side to side. Use shims where necessary.
2. Prior to placing cabinet against the wall, locate 3 studs or other wall frame members at
the level of the Top Panel (top of bed).
Alert: The cabinet must be secured to studs or other wall structural members using
2" x 2" (51x51mm) L-Brackets. If the wall is not a wood stud wall, use metal stud
screws, toggle bolts or concrete expansion bolts if necessary.
3. Now that the cabinet is square and plumb, use two #8x2" (M4x51mm) flat head wood
screws in each of three 2"x2" (51x51mm) brackets to attach to studs at the top level of
the Top Panel (see Drawing 9.). Re-check square and plumb and then secure 2"x2"
(51x51mm) L-Brackets to Top Panel with #8 x 3/4" (M4x19mm) wood screws. Attach
warning label to top of cabinet. Attach three Bumper Buttons to bottom of the front
edge of the Top Facia. These Bumpers allow the Bed Face Panel to close quietly.
Top Facia
Left
Side Panel
2"x2"
(51x51mm)
Warning
Angle
Label
Brackets
Rubber
Bumpers (3)
Wall
Studs
Drawing 9.
Right
Side Panel
11