Hideawaybeds alpha bed SBF Manual de instrucciones de montaje - Página 14

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Mobiliario interior Hideawaybeds alpha bed SBF. Hideawaybeds alpha bed SBF 18 páginas. Steel bed frame

Imprimir página

STEP 7: Install the Bed Face Panel Unit

Insert Allen Head Bolts through Hole #1 (6 3/4" from end of side frame) on both left

and right side frames (see Drawing 14). Thread on 5/16" (8mm) Nylock nuts and

securely tighten.

Insert two 5/16" (M8x20mm) Hex Head Bolts from the outside of the frame through

Hole #3 and put 5/16" (8mm) Nylock Nuts on these bolts only finger tight at this time.

Stand the Bed Face Panel in vertical position between the tension arms, lift evenly

until the bolt in Hole #3 drops in the slotted end of each tension arm. Gently tilt the

bed face toward you until the Allen Bolts in Hole #1 are completely seated in the

bottom notch of the tension arms. Insert the remaining 5/16" (8mm) Hex Head Bolts

through tension arms into Holes #2 and fasten with 5/16" (8mm) Nylock Nuts;

securely tighten these and the nuts on Hole #3.

Side Panel

Drawing 14.

When all bolts are securely tightened, you may tilt the panel outward to approximately

45 degrees to release the arm locks. You will hear a click as they disengage.

Caution:

Hold the Face Panel securely, Do Not let it slam shut. Balance is not achieved until

the mattress is loaded in the bed.

Leveling of the bed cabinet is essential. Check the level both side to side and front to

back. Proper leveling will facilitate proper closure and exact sight lines of the fit of the

Face Panel to the Cabinet.

Bed Panel

Face

Head of Bolt

in Hole #3

Bolt Hole #2

Allen Bolt in

Hole #1

Side Panel

Drawing 15.

Bed Panel

Unit Rail

Bolt Hole #3

seated in slot

Bolt Hole #2

Allen Bolt in

Hole #1 seated

in notch