AutomationDirect Leadshine DM542E Manual de inicio rápido - Página 8
Navegue en línea o descargue pdf Manual de inicio rápido para Accionamientos de CC AutomationDirect Leadshine DM542E. AutomationDirect Leadshine DM542E 17 páginas. Stepper drives
Imprimir página
DM322E
The DM322E is a compact drive capable of pulse and direction
operations, with auto-motor configuration on power up.
Specifications
Part Number
Output Current
Supply Voltage
Connector P1
Pin Function
Connector P2
Pin Function
Connecting Devices to the DM322E Drive
4-lead motors are the easiest to connect, and the speed – torque of the motor depends on winding
inductance. To determine the output current of the drive, multiply the nameplate motor phase current
by 1.4 to determine the peak output current. If the motor runs too hot then multiply by 1.2 instead. For
6-lead and 8-lead motor wiring information, please refer to the drive User Manual.
The drives are designed to operate within a specific voltage input (see specifications table). When
selecting a power supply, choose a power supply with an output range within the minimum and
maximum of the drive and be sure to leave room for power supply fluctuation and motor back-EMF.
The DM322E drive can be connected for either sinking or differential control signals. Wire the
connections to the motor, power supply, and controller according to the diagrams on the next page:
Leadshine Stepper Drives Quick Start Guide – First Edition – 11/04/2019
Electrical, Connector, and Environmental Specifications
Pulse signal: 5V signal, single-ended input� High input is
PUL
4-5V, Low input is 0-0.5 V. Minimum pulse width = 2.5 μs.
Add a 1kꭥ resistor for +12V signals, 2kꭥ for +24V signals.
DIR signal: 5V signal, single-ended input� High input is 4-5V,
Low input is 0-0.5 V. Minimum pulse width = 2.5 μs. Add a
DIR
1kꭥ resistor for +12V signals, 2kꭥ for +24V signals.
Direction Function: requires 5μs setup time.
CW/CCW Function: see DIP switch SW14�
This input is the voltage supply for the Pulse, Direction, and
OPTO
Enable opto-couplers. Connect 5VDC (or +12V, +24V with
appropriate resistors on Pulse, Direction, and Enable inputs)�
Enable signal: 5V signal, single-ended input� High input is
4-5V, Low input is 0-0.5 V. Minimum pulse width = 2.5 μs.
ENA
Add a 1kꭥ resistor for +12V signals, 2kꭥ for +24V signals.
Enable Function: Close (pull low) to disable the drive�
GND
Power supply ground connection�
+V
Power supply positive connection�
Motor phase A connections. Connect motor A+ wire to A+
A+,A-
pin, motor A- wire to A- pin�
Motor phase B connections. Connect motor B+ wire to B+
B+,B-
pin, motor B- wire to B- pin�
Leadshine Stepper Drives Quick Start Guide
DM322E
0�3–2�2 A peak
(0�2–1�6 RMS)
12–30 VDC
(24 VDC typical)
Page 8 of 17