AutomationDirect CLICK C0-08SIM Manual - Página 2

Navegue en línea o descargue pdf Manual para Unidad de control AutomationDirect CLICK C0-08SIM. AutomationDirect CLICK C0-08SIM 3 páginas. Expansion i/o module

Imprimir página

C0-08SIM CLICK Expansion I/O Module

Installation and Mounting

1. Safety Installation, Wiring or Handling

• Discharge static electricity before installation or wiring, in order to avoid electric

equipment damage.

2. Preface

• CLICK C0-08SIM is supported by CLICK Programming software Ver 2.60

or higher.

Installing Expansion I/O Modules:

1. Remove protective cover over buss port.

2. Push the LOCK slide (top and bottom of modules) to "UNLOCK".

3. Align module pins and tabs (attachment of modules) into adjacent slots and

firmly push together.

4. Push the LOCK slides to "LOCK" to lock modules rigidly together.

Modules easily connect to each other.

OPEN

To remove an I/O module, first disconnect all phases of external

power source and wait

5 seconds

expansion I/O module of a functioning system.

Then push LOCK slides to "UNLOCK" and gently separate modules.

www.automationdirect.com/click-plc

Locking Tabs (Top and Bottom)

CLOSED

before installing or removing the

Additional Help and Support

• For additional technical support and questions, call our

Technical Support team @ 1-800-633-0405 or 770-844-4200

Safety Installation

Please heed the following instructions when

installing:

• Mount the CLICK PLC unit horizontally to provide

proper ventilation.

• Do not mount the CLICK PLC unit upside down, on

a horizontal surface, or in a vertical arrangement.

• There is a minimum clearance requirement of

2in. (51mm) from all sides of the cabinet and the

equipment.

• There is a minimum clearance requirement of 3in.

(76mm) from the wiring ducts and the equipment.

• Please use this product in a metal enclosure/cabinet.

Air

Flow

Enclosures

It is important to select the appropriate enclosure to ensure safe and proper

operation of your CLICK PLC system. Control applications vary, and yours may

require additional considerations. At a minimum your enclosure should include

the following:

• Conformance to electrical standards

• Protection from the elements in an industrial environment

• Common ground reference

• Maintenance of specified ambient temperature

• Access to equipment

• Security or restricted access

• Sufficient space for proper installation and maintenance of equipment

• When installing modules and CPU on DIN rails, always

use end brackets on both ends of assembly.

• You should use 35mm width DIN Rails.

• You should use M4 size screws when you surface mount.

• You should tighten the screws with a spring washer and

a small round washer and torque (0.5 to 0.6 N·m).

Do not operate without first installing safety cover

over power supply leads.

CLK-2

CLICK Module Insert

3505 HUTCHINSON ROAD

CUMMING, GA 30040-5860

Minimum clearance requirement

51mm

of 51mm for A, B, and C.

CAUTION

1-800-633-0405