Gait up Physilog 5 Manual del usuario - Página 2

Navegue en línea o descargue pdf Manual del usuario para Sensores de seguridad Gait up Physilog 5. Gait up Physilog 5 12 páginas.
También para Gait up Physilog 5: Manual del usuario (17 páginas), Manual del usuario (17 páginas)

Imprimir página

1. Physilog®5 elements

2. Charging

The Physilog®5 is charged via the microUSB port. Plug the microUSB connector of the cable

delivered with the Physilog®5 to the Physilog®. Plug the USB connector to a Computer or

Charger (see voltage specifications below).

Warning: Be careful to plug the microUSB cable in the correct orientation into the Physilog®,

forcing the connector may permanently damage the Physilog® and compromise its

waterproofing.

Low battery level is indicated by orange blinking during measurement or if the Physilog®

blinks rapidly 3 times red when starting and doesn't start the recording (see LED indications

below). A battery level estimation is available in the mobile application. When the Physilog®

is discharged, plug it for charging for at least 30 minutes before use.

It is recommended to avoid complete discharging of the Physilog®5, therefore check that the

Physilog® sensors are off when you store them. After a long period without using the

Physilog®, plug it for charging for at least 30 minutes before use. It may happen that the LED

doesn't blink orange at the beginning of charging after the battery was very low, to see the

charging ongoing shortly push the main button or disconnect and reconnect after some

charging time.

Supply Voltage specifications

The Physilog® 5 should be charged using USB at 4.2V, 100mA. For charging, the ambient

temperature must lie between 0°C and 45°C.