ADEMCO 6137 Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Control Panel ADEMCO 6137. ADEMCO 6137 9 páginas. Remote keypads
También para ADEMCO 6137: Manual de instalación (2 páginas), Manual rápido (3 páginas), Manual de instalación (2 páginas), Manual de instalación (2 páginas)

A fire alarm sends a fire alarm message to the alarm monitoring company* and uniquely activates keypad and any

external sounders (FIRE plus a zone number is also displayed).

Fire Alarm System

Fire Alarm System (If Installed)

Your fire alarm system (if installed) is active 24 hours a day, providing continuous protection. In the event of an

emergency, the installed smoke and heat detectors will automatically activate you security system, triggering a loud,

interrupted sound from the Keypad. An interrupted sound will also be produced by optional exterior sounders. A FIRE

message will appear at your Keypad and remain on until you silence and clear the alarm display.

Should you become aware of a fire emergency before your detectors sense the problem, go to your nearest Keypad and

press the single panic key (or panic key pair) assigned as FIRE emergency (if programmed by the installer) and hold down

for at least 2 seconds. The alarm will sound.

If no flames or smoke are apparent, investigate the cause of the alarm. The zone descriptor of the zone(s) in an alarm

condition will appear at the Keypad.

Silencing a Fire Alarm:

1. Silence the alarm by pressing the OFF key. To clear the alarm display, enter your code and press the OFF key

again.

2. If the Keypad indicates a trouble condition after the second OFF sequence, check that smoke detectors are not

responding to smoke or heat producing objects in their vicinity. Should this be the case, eliminate the source of

heat or smoke.

3. If this does not remedy the problem, there may still be smoke in the detector. Clear it by fanning the detector

for about 30 seconds.

4. When the problem has been corrected, clear the display by entering your code and pressing the OFF key.

Trouble Conditions

Typical "Check" Displays

The word CHECK on the Keypad's display, accompanied by a rapid "beeping" at the Keypad, indicates that there is a

trouble condition in the system. The displays in parenthesis may appear on non-alpha keypads when the associated

trouble condition is present.

To silence the beeping sound for "check" conditions, press any key. Note that zone number 9 represents a problem with

wireless receivers or other system devices, which are not user serviceable. Call for service immediately.

CHECK + Zone Descriptors

Indicates that a problem exists with the specified zone(s). First, determine if the zone(s) displayed are intact and make

them so if they are not. If the zone uses a wireless detector, check that changes in the room (moving furniture,

televisions, etc.) are not blocking wireless signals from the detector. If the problem has been corrected, the zone

descriptor(s) and CHECK should disappear. If not, key an OFF sequence (security code plus OFF) to clear the display. A

CHECK condition can also indicate a wiring problem. If the "check" display persists, call for service immediately.

Note that the system will not allow arming if a CHECK condition exists. To arm the system with a CHECK condition

present, you must first bypass the zone(s) having the CHECK condition.