ActivePure Induct Guardian I Manual - Página 9

Navegue en línea o descargue pdf Manual para Limpiador de aire ActivePure Induct Guardian I. ActivePure Induct Guardian I 16 páginas.

REPLACING THE BALLAST

• UV Light in operation; disconnect unit from power cord before servicing; failure

to follow warnings may result in severe eye damage

• Disconnect power at the breaker or fuse panel before servicing unit;

always follow OSHA lockout procedures to prevent accidental exposure to

electrical energy

WARNING

Power

Cord

1. Disconnect (unplug) power cord from unit.

NOTE: Always follow OHSA electrical lockout safety requirements to prevent accidental release of energy

during service or maintenance activities.

3. Disconnect all ballast wiring by pressing

down on connector tabs and pulling wire

straight out.

5. Place new ballast into original location and secure using the two (2) nuts removed in step 4.

2. Open the ballast housing by removing the

four (4) screws then removing the cover.

4. Remove the two (2) nuts securing ballast to

the case. Remove the ballast.