Gakken Stirling engine Instrucciones de montaje y funcionamiento - Página 4
Navegue en línea o descargue pdf Instrucciones de montaje y funcionamiento para Juguete Gakken Stirling engine. Gakken Stirling engine 12 páginas.
Imprimir página2
2
Figure ー
Attach the body holding parts.
Fasten the A2, the
A3 and the A4 body
holders with screws
(6mm).
screw (6mm)
A2
body holder
3
3
Figure ー
Assemble the alcohol lamp
①Attach the A10
and attach it to the A1 stand.
wick holder to the A9
alcohol holder and
①
set them on the A8
alcohol tray. (Roll the
wick and put it in the
alcohol tray. Do not
fill the fuel alcohol
until just before the
experiment.)
②Fasten the alcohol
lamp to the A1 stand
with screws (6mm).
A4
screw (6mm)
body holder
screw (6mm)
screw (6mm)
A3
body holder
A2
body holder
screw (6mm)
screw
(6mm)
A1
stand
A10
wick holder
A9
alcohol holder
screw(6mm)
screw(6mm)
A8
alcohol tray
A9
alcohol holder
②
A1
stand
6
2
Attaching Wheels to the Body
Parts to be used
B1
body
B2
Two
front wheels
※Check the difference in the size of the
shaft hole between the front wheels
and the rear wheels.
4
Figure ー
①Put four B4 tires on the
B2 front wheels and the
B3 rear wheels.
②Attach the front wheels
to the B5 front wheel
holder with hexagon
screws (10mm).
screw(6mm)
③Attach the rear wheels
to the B7 rear wheel shaft
with hexagon screws
(4mm).
Full-scale
※Check the size with this.
10mm hexagon screws
※These are for the front wheels.
4mm hexagon screws
※These are for the rear wheels.
Warning ★ Fire is used for the experiment. Use great caution to avoid
a burn and fire. Do not let a 15 or less-year-old child experiment alone.
PARTS
B
※ There may be more screws, washers, nuts
and bushes than actually used for spare.
Two 10mm
B4
B3
Four
tires
hexagon screws
Two
※These are for the
rear wheels
front wheels.
Two 4mm
hexagon screws
※These are for the
rear wheels.
One 6mm
large nut
4
Assemble the wheels.
The width of the
inside projection
②front wheels
is 4mm.
(with big holes)
hexagon screws
(10mm)
③rear wheels
(with small holes)
B5
front wheel holder
hexagon
screws
(4mm)
The width
The width of the
of the
inside projection
outside
is 4mm.
projection
is 2.5mm.
7
B5
front wheel holder
B6
B7
Two
rear wheel holders
rear wheel shaft
Two 6mm
screws
One
7mm bush
One 18mm
screws
One
9mm spring
Two 7mm
across washers
One 8mm
※Check the length of screws
with these diagrams.
across washer
①
B4
tire
The width of the
outside projection
is 2.5mm.
B7
rear wheel shaft
hexagon
screws
(10mm)
hexagon
screws
The width of the
(4mm)
outside projection
is 2.5mm.