Airdream MotoAir Instrucciones de uso - Página 2
Navegue en línea o descargue pdf Instrucciones de uso para Accesorios Airdream MotoAir. Airdream MotoAir 8 páginas. Inflatable
Erecting your Inflatable Awning
Before you unpack your awning we strongly advise that you place a groundsheet
in front of the caravan. This will avoid any soiling of the fabric or penetration by
stones or twigs. Erecting the awning is a relatively simple task and we trust the
following information will be of valuable assistance to the new camper.
However we would advise the inexperienced camper to seek advice from the
dealer.
1. Always site your awning on a flat piece of ground this will enable you to obtain
the best possible fit of your awning.
2. Check that your awning rail is clean and free from any sharp edges which could
easily damage the fabric or awning beading.
3. You are now ready to start erecting your awning. To make the task easier we
would always suggest that two people will make erecting the awning a much
easier task.
4. Start by threading the white/grey beading into the awning rail with one person
pulling the awning through the rail. The other person should be feeding the
beading into the rail ensuring that it runs smoothly. Position the awning so that
it clears windows, doors, etc. Secure the awning in the correct position by
pegging out the four corner tabs. Attach the inflator to the inflation valve; inflate
to an optimal pressure of 7-8psi.
During the latter part of inflation it may be necessary to lift the tubes into the
correct position. When you have inflated to the correct pressure disconnect the
inflator ensuring that you have securely tightened the valve cap. Be careful not to
cross thread this cap.
2/8