Dynamic Projection MH29 Manual de instalación rápida - Página 4
Navegue en línea o descargue pdf Manual de instalación rápida para Accesorios para proyectores Dynamic Projection MH29. Dynamic Projection MH29 8 páginas. Mirror head
Mirror Head Quick Installation Guide
For the full manual please visit
Mounting of the projector
For further help on assembly please watch our assembly videos: http://www.dynamicprojection.com/mirror-head-assembly/
MH29
7.
7 .
Mount the base-plate and the provided accessories to the projector.
WARNING: Secure the projector at any time so it cannot fall out or down. Use a second person to help.
8.
Lock-in the Mirror Head into the base-plate and secure the two screws at the front and the two screws at the bottom.
NOTE: This step of the installation can be reversed.
9.
Connect the RS232 and AC power-cord to the projector and control unit.
Copyright © 2014 - 2022 by Dynamic Projection Institute GmbH. All rights reserved. http://www.dynamicprojection.com
http://dynamicprojection.com/mirror-head-assembly
5
1
2
3
4
8.
Weights and dimensions shown are approximate. Specifications and appearance are subject to change without notice.
6
7.
4
E
1.
Prepare the setscrew on the hex key.
2.
Turn the setscrew into the drive arm
by two turns.
3.
Slip over the end-stop (brass part)
over the pan drive shaft.
4.
Take the whole drive arm end slip it
over the pan drive shaft until it
reaches the end-stop.
5.
Secure the setscrew with the hex key.
Make sure that the screw is tightened
on the flat side of the D-cut shaft.
6.
Connect the motor signal cable and
mount the glue strip on the motor.
Flat side
8.
MH30
QIG - Version 2.6