Hifionics Gladiator GLX1000.1D Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Amplificador de coche Hifionics Gladiator GLX1000.1D. Hifionics Gladiator GLX1000.1D 16 páginas. High performance amplifiers
Imprimir páginaGLX60.4 / GLX100.4 4-CHANNEL AMPLIFIER APPLICATIONS
Front/Rear high pass, using a 1 channel amplifier for mono sub bass
The combination of a 1 and a 4 channel amplifier, utilizing their built in
crossovers, makes it a snap to put together a full system with front and rear
highs, with mono sub bass.
Interconnect cable checklist:
- Using good quality RCA cables, feed the front and rear outputs of a head unit to
the inputs of the 4 channel amplifier as shown.
- Also connect the LINE OUT of the 4 channel amplifier to the LINE INPUT of the
1 channel amplifier as shown.
Mono bass woofer wiring:
Connect the mono speaker positive terminal to the LEFT +, and its negative
terminal to RIGHT -.
Switch setting checklist:
4 channel highs amplifier:
- 1/2CH X-OVER: HI
- 3/4CH X-OVER: HI
Crossover frequency control checklist:
- 4 channel highs amplifier:
Channels 1/2:
- HI PASS: 100 Hz
LOW PASS: N/A
STEREO
INTERCONNECT
RCA CABLE
Channels 3/4:
- HI PASS: 100 Hz
- LOW PASS: N/A
1 channel bass amplifier:
- Subsonic filter: 10 Hz to 40 Hz
- LOW PASS: 80 Hz
Please note that these frequency points are suggestions only. Refer to the
loudspeaker manufacturer specifications and the section "Setting up systems
after installation for best performance"
Level control checklist:
- Refer to the section "Setting up systems after installation for best performance"
Minimum final loudspeaker impedances:
4 Channel Amplifier:
- 2 ohm per channel in stereo mode.
- 4 ohm mono bridged.
1 Channel Amplifier:
- 1-Ohm to 4-Ohms
MONO
SUBWOOFER
1-OHM MINIMUM
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
4