Galak Electronics VG-212 Manual - Página 6

Navegue en línea o descargue pdf Manual para Juguete Galak Electronics VG-212. Galak Electronics VG-212 6 páginas. Singing santa

Powering up the Singing Santa

Now that you have completed the assembly of your Singing Santa Sequencer, you are ready to

power it up. Insert two (2) CR2032 batteries with the "+" side up, sliding the first battery under

the clip. The second battery will require pulling the clip up slightly and will snap firmly into place.

Your Singing Santa should start up immediately. The entire duration off the music and LED show

should last about two and a half minutes. Once the entire cycle is complete, your unit will go into

a power down mode, consuming just 80 µA of power (Please note: We advise removing the

batteries for long periods of inactivity).

To start the cycle again, press the button. The first pattern in the sequence will flash all the

LEDs simultaneously while playing Deck the Halls. When the song finishes, the LEDs will start

the first sequence, sweeping the LEDs from top to bottom. Next the LEDs will light in a random

pattern. The last sequence will light the LEDs in a pendulum type motion. These three patterns

will repeat 9 times for an overall duration of about 2 minutes.

If you don't get any response from your Singing Santa after applying power, check your

connections. If you still don't get any response please contact Galak industries for further

troubleshooting hints. In the event that the problem can't be resolved, we will be happy to repair

your unit free of charge. You just pay the shipping costs.

SPECIFICATIONS:

Supply Voltage

Standby Current

Sequential Pattern

Pattern Select

Board Dimensions

Board Material

Finished Weight

Good luck and enjoy you new Singing Santa. We appreciate your business.

Galak Electronics

Electronic kits and components

6VDC @ 15mA

Approximately 80µA (battery life approximately 3 months)

Downward sweeping, random and pendulum motion

Single pushbutton to power up sequence

2.0" x 3.5" (5.0mm x 6.6 cm) approximate

0.062" (1.6 mm) FR-4, with white solder mask and top/bottom

layer silk screen

0.9 ounces (24 grams)

Email:

Phone: (302) 832-1978