Autonics BS3 Series Manual del producto
Navegue en línea o descargue pdf Manual del producto para Accesorios Autonics BS3 Series. Autonics BS3 Series 3 páginas. Groove-depth 6.5 mm photomicro sensors
Imprimir página
TCD210179AC
Groove-Depth 6.5 mm
Photomicro Sensors
BS3 Series
PRODUCT MANUAL
For your safety, read and follow the considerations written in the instruction
manual, other manuals and Autonics website.
The specifications, dimensions, etc. are subject to change without notice for product
improvement. Some models may be discontinued without notice.
Features
• Ultra compact size
• Select appearance depending on the installation environment (K, F, R, U, L type)
• Minimize malfunction and improve visibility
- Minimize sensing part, gap and flush of the body to reduce malfunctions caused by
a foreign substance
- Built-in the operation indicator can be checked in many directions
• Selectable models for the operation of indicator
- Indicator turns ON under the light received condition
- Indicator turns ON under the light interrupted condition
• Resistant structure for shock and vibration
- Shock 15,000 m/s
(approx. 1,500 G)
2
- Vibration 10 to 2,000 Hz (1.5 mm double amplitude)
• Selectable operation modes (Light ON/Dark ON)
• High-frequency response : 2 kHz
ᜢ ᜨ
Safety Considerations
• Observe all 'Safety Considerations' for safe and proper operation to avoid hazards.
• symbol indicates caution due to special circumstances in which hazards may occur.
Warning
Failure to follow instructions may result in serious injury or death.
01. Fail-safe device must be installed when using the unit with machinery that
may cause serious injury or substantial economic loss. (e.g., nuclear power
control, medical equipment, ships, vehicles, railways, aircraft, combustion
apparatus, safety equipment, crime/disaster prevention devices, etc.)
Failure to follow this instruction may result in personal injury, economic loss or fire.
02. Do not use the unit in the place where flammable/explosive/corrosive gas,
high humidity, direct sunlight, radiant heat, vibration, impact or salinity
may be present.
Failure to follow this instruction may result in explosion or fire.
03. Do not disassemble or modify the unit.
Failure to follow this instruction may result in fire.
04. Do not connect, repair, or inspect the unit while connected to a power
source.
Failure to follow this instruction may result in fire.
05. Check 'Connections' before wiring.
Failure to follow this instruction may result in fire.
Caution
Failure to follow instructions may result in injury or product damage.
01. Use the unit within the rated specifications.
Failure to follow this instruction may result in fire or product damage.
02. Use a dry cloth to clean the unit, and do not use water or organic solvent.
Failure to follow this instruction may result in fire.
Cautions during Use
• Follow instructions in 'Cautions during Use' . Otherwise, it may cause unexpected
accidents.
• Use the product, 0.5 sec after supplying power. When using separate power supply for
the sensor and load, supply power to sensor first.
• The power supply should be insulated and limited voltage/current or Class 2, SELV
power supply device.
• Wire as short as possible and keep it away from high voltage lines or power lines to
prevent surge and inductive noise.
• When using a sensor with a noise-generating equipment (e.g., switching regulator,
inverter, and servo motor), ground F.G. terminal of the equipment.
• This unit may be used in the following environments.
- Indoors (in the environment condition rated in 'Specifications')
- Altitude max. 2,000 m
- Pollution degree 3
- Installation category II