Galanz RED380JDH-PAHH0A Manual del usuario - Página 17
Navegue en línea o descargue pdf Manual del usuario para Horno microondas Galanz RED380JDH-PAHH0A. Galanz RED380JDH-PAHH0A 19 páginas. 1.4cu.ft. oven-the-range microwave
Imprimir página
Waveguide Cover
The waveguide cover is on the right side of the cavity. It is made from mica so requires special care.
Keep the waveguide cover clean to assure good oven performance. Carefully wipe with a damp cloth
any food spatters from the surface of the cover immediately after they occur. Built-up splashes may
overheat and cause smoke or possibly catch fire. DO NOT REMOVE THE WAVEGUIDE COVER.
Odor Removal
Occasionally, a cooking odor may remain in the oven. To remove, combine 1 cup water, grated peel
and juice of 1 lemon and several whole cloves in a 2-cup glass measuring cup. Boil for several minutes
using 100% power. Allow to set in oven until cool. Wipe interior with a soft cloth.
Turntable/Turntable Support
The turntable and turntable support can be removed for easy cleaning. Wash them in mild, sudsy
water; for stubborn stains use a mild cleanser and non-abrasive scouring sponge as described above.
They are also dishwasher-proof. Use upper rack of dishwasher. The turntable motor shaft is not sealed,
so excess water or spills should be wiped up immediately.
Grease Filters
Filters should be cleaned at least once a month. Never operate the fan or oven without the filters in
place.
Pull down slightly on the tab toward the front of the oven and remove the filter. Repeat for the other
filter.
Soak the filter in a sink or dish pan filled with hot water and detergent. DO NOT use ammonia or other
alkali; they will react with the filter material and darken it.
Agitate and scrub with a brush to remove embedded dirt.
Rinse thoroughly and shake dry.
Replace by fitting the filter back into the opening.
Light
Unplug or Disconnect power.
remove the screw on the glass window frame.
Screw off the bulbs from the lamp sockets carefully and replace them .
DO NOT USE A BULB LARGER THAN 30 WATTS.
Close glass window frame and secure with screw removed in step 2.
16