Aire-Flo 30 Manual de instrucciones de instalación - Página 2
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Aire acondicionado Aire-Flo 30. Aire-Flo 30 18 páginas. 14 seer
Imprimir página
WARNING
To prevent personal injury, as well as damage to panels,
unit or structure, observe the following:
While installing or servicing this unit, carefully stow all
removed panels so that the panels will not cause injury
to personnel, objects or nearby structures. Also, take
care to store panels where they will not be subject to
damage (e.g., being bent or scratched).
While handling or stowing the panels, consider any
weather conditions (especially wind) that may cause
panels to be blown around and damaged.
NOTICE !
Roof Damage!
This system contains both refrigerant and oil. Some
rubber roofing material may absorb oil, causing the
rubber to degrade. Failure to follow this notice could
result in damage to roof surface.
IMPORTANT !
Exhaust vents from dryers, water heaters and fur
naces should be directed away from the outdoor unit.
Prolonged exposure to exhaust gases and the chemi
cals contained within them may cause condensation
to form on the steel cabinet and other metal compo
nents of the outdoor unit. This will diminish unit per
formance and longevity.
PLACEMENT
INSTALL UNIT AWAY
FROM WINDOWS
TWO 90º ELBOWS INSTALLED IN LINE SET
FIGURE 2
WILL REDUCE LINE SET VIBRATION
Install unit level or, if on a slope, maintain slope tolerance of 2
degrees (or 2 inches per 5 feet [50 mm per 1.5 m]) away from
building structure.
BUILDING
STRUCTURE
STEP 2 -- REFRIGERANT PIPING -- Flush
ing Existing Line Set and Indoor Coil
Flush the existing line set per the following
instructions. CAUTION - DO NOT attempt to flush and
re-use existing line sets or indoor coil when the
system contains contaminants (i.e., compressor burn
out).
If this unit is being matched with an approved line
set or indoor unit coil that was previously charged
with mineral oil, or if it is being matched with a coil
which was manufactured before January of 1999,
the coil and line set must be flushed prior to installa
tion. Take care to empty all existing traps. Polyol es
ter (POE) oils are used in units charged with
HFC-410A refrigerant. Residual mineral oil can act
as an insulator, preventing proper heat transfer. It
can also clog the expansion device and reduce sys
tem performance and capacity.
Fire, Explosion and Personal Safety
Hazard. Failure to follow this warning
could result in damage, personal injury or
death.
Never use oxygen to pressurize or purge
refrigeration lines. Oxygen, when ex
posed to a spark or open flame, can
cause fire and/or an explosion, that could
result in property damage, personal inju
ry or death.
Page 2
SLAB MOUNTING
DISCHARGE AIR
MOUNTING SLAB
GROUND LEVEL
FIGURE 3
IMPORTANT !
WARNING