ADENDORFF MC900 Manual de instrucciones - Página 11

Navegue en línea o descargue pdf Manual de instrucciones para Torno ADENDORFF MC900. ADENDORFF MC900 18 páginas. Variable speed wood lathe

spindle using the two wrenches provided [2]

Spurs

1. Remove the faceplate [1] from the headstock

to separate the faceplate from the spindle nut.

(Figure 5)

2. Insert the headstock spur [31 in the spindle hole.

3. Insert the tailstock center (4] in the

tailstock hole. (Figure 6)

4. To remove either the headstock spur or the

tailstock center, insert the push-out rod [5]

into the hole (6] at the opposite end

m� , � �

1�r � , � uti m �

headstock or-t a ilstock. Remove and store the

Faceplate (Figure 7)

1. Remove the headstock spur from the spindle.

2. Thread the 4 inch diameter faceplate le the

spindle.

3. Mount the workpiece to the faceplate with the

flat head brass wood screws. Make sure the

length of the screws does not interfere wilh

the cutting tools.

Extension bed (Figure 8)

1 . The extension bed is attached to the left of

the headstock for outboard faceplate turning

when the use of the tool rest is required.

2. If outboard faceplate turning does not

require the use of the tool rest, do not attach

the extension bed until needed.

3. To attach the extension bed [11 to the bed,

align the bolt holes [2] with the threaded bed

holes [3]. Put the lock washer [4] on the hex

bolt [5]. First finger tighten the hex bolt, then

secure the hex bolt with the hex key provided.

'---- --- ---- ---- - �11 '-- - - ----- -- - -- -- �

VI • Assembly

the

1��r ��,

Fig. 6

Fig. 7