ADENDORFF CM650 Manual de información operativa - Página 5

Navegue en línea o descargue pdf Manual de información operativa para Mezclador ADENDORFF CM650. ADENDORFF CM650 10 páginas. Concrete mixer

1. CAUTION: Do not attempt to move the Cement Mixer when it is full and/or in operation.

2. Place the Cement Mixer on a solid, flat, and level surface that is capable of supporting the weight of

the mixer and it's load.

3. Start the Engine (part

in the Engine manufacturer's operating manual.

4. NOTE: Filling and emptying the Drum (part #4) is best done with the Drum rotating. DO not turn

off the Cement Mixer while full of cement.

5. With the Drum (part #4) operating between 20-36RPM, the Cement Mixer is now ready for the

addition of the concrete

6. To determine the proper amount of water, gravel, cement, and sand, refer to

Figure A

MIX VOLUME (CU.FT.)

Cement (Bags)

Water (Gal.)

Sand (Gal./Shovels)

Gravel (Gal./Shovels)

7. For best results, proceed as follows:

A. Pour the required amount of water into the Drum (part #4)

B. Add the required amount of gravel into the Drum.

C. Add the required amount of cement into the Drum.

D. Add the required amount of sand into the Drum.

8. Allow adequate time for the water, gravel, cement and sand to thoroughly mix.

9. To discharge the cement mix, grasp the Hand Wheel (part #51) firmly with one hand

Brake Handle (part #60). Then, slowly turn the I-land Wheel counterclockwise to empty the Drum

(part #4). CAUTION: To prevent accidental discharge of the cement mix, do not release the Brake

Handle without holding the Hand Wheel firmly. Always make sure the Brake Handle is fully engaged

after

#45),

and allow it to reach the appropriate operating temperature as instructed

SAMPLE MIX VOLUME

1/2

2-1/2

Mix volume may vary depending on aggregate used.

FIGURE A

2/3

3-1/2

5-1/4

and

release the