909 254CMS Manual de instrucciones - Página 18
Navegue en línea o descargue pdf Manual de instrucciones para Sierra 909 254CMS. 909 254CMS 19 páginas. 1800w 255mm (10") single bevel laser guided compound mitre saw
Imprimir página
Using the laser line generator
WARNINGS
Do not stare directly at the laser beam.
Never aim the beam at any person or an object other than
the workpiece.
Do not deliberately aim the beam at personnel and ensure
that it is not directed towards the eye of a person for longer
than 0.25 second.
Always ensure the laser beam
is aimed at a sturdy workpiece
without reflective surfaces.
Wood or rough coated
surfaces are acceptable.
Bright shiny reflective surfaces
are not suitable for laser use
as the reflective surface could
direct the beam back at the
operator.
Always remember to switch off the laser on/off switch (26)
after finishing a job. Only turn the laser beam on when the
workpiece is on the mitre saw table.
1. Mark the line of the cut on the workpiece.
2. Adjust the angle of mitre and bevel of the cut as required.
3. Switch on the laser light on/off switch (26) (Fig. t).
4. Clamp the workpiece in position using the laser lines to
align the blade with the pencil mark on the workpiece.
Maintenance
WARNING.
Always ensure that the tool is switched off and
the plug is removed from the power point before making any
adjustments or maintenance procedures.
•
Any damage to this tool should be repaired and carefully
inspected before use, by qualified repair personnel.
•
Have your power tool serviced by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
t
•
Global Power Brands will not be responsible for any
damage or injury caused by unauthorized repair or
mishandling of the tool.
Power cord maintenance
If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer's agent, or an
authorised service centre in order to avoid a safety hazard.
Cleaning
1. Keep the tool's air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a soft brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION.
Do not use cleaning agents to clean the
plastic parts of the saw. A mild detergent on a damp cloth
is recommended.
General inspection
Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
18