dbx iEQ-15 Manual del usuario - Página 15

Navegue en línea o descargue pdf Manual del usuario para Ecualizador estéreo dbx iEQ-15. dbx iEQ-15 20 páginas. Graphic eq
También para dbx iEQ-15: Manual del usuario (16 páginas), Especificaciones (2 páginas), Resumen rápido (4 páginas)

Imprimir página

iEQ

Quick Start

This section explains the procedure for using the iEQ Series EQs for tuning the left and right front of

house speakers in a live sound system�

Using the iEQ in AFS Normal Mode

Use this method when you do not intend to initially ring out the sound system before use� This is the

fastest and easiest way to utilize AFS�

1. Configure the iEQ for AFS Normal Mode operation within the Power-Up Mode menu as

described in the "Power-Up Modes" section of this manual�

2. Set all controls as follows:

• Both AFS buttons = Off (LEDs off)�

• Both TYPE V™ NR buttons = Engaged (LEDs on)

• Both EQ BYPASS buttons = Disengaged (LEDs off)

• Both INPUT GAIN controls = 0dB

• Both LOW CUT buttons = Engage these buttons (LEDs on) as long as you do not have

a low cut filter engaged in an active crossover, loudspeaker management processor, your

amplifier(s), or powered speakers� If you do have a low cut filter engaged somewhere in the

signal chain, post iEQ, leave these buttons disengaged (LEDs off)�

• Both PeakStopPlus

• Both RANGE +/-15 buttons = Engaged (LEDs on)

NOTE: Whenever amplifiers are powered on, be sure to reduce audio levels at the power

amplifiers when changing the setting of this switch as it may generate an audible transient�

• All EQ Frequency Band sliders = Flat (center detent)

3. For best performance, set the gain structure of the sound system� This is beyond the scope

of this manual, but there is much information about this process in books and on the

internet� This is when you will determine where the iEQ's INPUT GAIN controls need to

be initially set (they may require further adjustment after equalizing the sound system as EQ

changes may change the output gain of the iEQ processor)� This is also when you will set the

PeakStopPlus

dedicated limiters, the limiters within a loudspeaker management processor, powered speakers

with built-in limiters, or any limiters post iEQ, set the iEQ's PeakStopPlus

controls to the "OFF" position�

4. Using a reference CD, a known and trusted vocal mic, or a real time analyzer and calibrated

microphone, EQ the sound system to taste�

5. Press and release each AFS button until they are both lit yellow�

This completes the iEQ setup process�

LIMITER controls = OFF

LIMITER controls, if using the iEQ for speaker protection� If you are using

Operation

LIMITER

iEQ User Manual