909 TCAT235 Manual de instrucciones - Página 11

Navegue en línea o descargue pdf Manual de instrucciones para Sierra 909 TCAT235. 909 TCAT235 17 páginas.

Imprimir página

Note.

Always make a trial cut in a scrap piece of material

along a guideline to determine how much you should offset

the blade from the guideline to make an accurate cut.

Switching on and off

1. Connect the plug to the power supply.

2. Depress the lock-off button (Fig. F) and squeeze the On/

Off trigger switch (Fig. G).

3. The blade will take approximately 2 seconds to reach

full speed.

4. When you release the On/Off trigger switch, the machine

turns off and the lock-off button re-engages to prevent

accidental operation.

CAUTION.

Allow the blade to come to a complete standstill

before setting the saw down.

Making a cut

1. Mark the line of cut on the work piece.

2. Adjust the depth of cut and bevel angle as required.

3. When making 90° cross or rip

cuts, align your line of cut with

the outer blade guide notch on

the base of the saw (Fig. H).

4. When making 45° bevel cuts,

align your line of cut with the

inner blade guide notch on the

base of the saw.

5. Rest the front edge of the

base on the work piece (Fig. I).

Blade guide notch

6. Start the motor by depressing

the lock-off button and

squeezing theOn/Off trigger

switch.

Note.

Always let the blade reach

full speed (approximately

2 seconds) before you begin

to cut into the work piece.

7. Slowly push the saw forward

using both hands (Fig. J).

8. When making a cut always

use steady, even pressure.

Forcing the saw causes rough

cuts and could shorten the life

of the saw or cause kickback.

Allow the blade and the saw to

do the work.

9. After completing your cut, release the trigger switch

and allow the blade to come to a complete stop.

Do not remove the saw from the work piece while the

blade is moving.

Note.

Since blade thickness varies, always make a trial

cut in scrap material along the guideline to determine how

much, if any, the guideline must be offset to get an

accurate cut.

Making a pocket cut

1. Adjust the depth of cut as

required.

2. Adjust the bevel setting to 0°.

3. Raise the lower blade guard

lever to expose the saw blade

and firmly rest the front of

the base flat against the work

piece with the rear handle

raised so the blade does not

touch the work piece (Fig. K).